This reducer/flattener is optimized for our 80 mm triplet lens. It will also work for the Lomo 80 triplet. The flattener threads into the Feather Touch or Stellarvue 2.5” focuser. It will also work with a standard 2” focuser for earlier models. 0.8X focal reduction converts the 80 mm f-6 to f-4.8.
This reducer/flattener has a standard 48 mm filter thread. Standard 2" filters can be added to the reducer flattener when imaging. The backfocus of the unit is 55 mm. Since a DSLR with t-ring has a 55 mm backfocus, thread it into the cameras t-ring, then screw it to the focuser as shown below.
If you are using a CCD camera, an additional set of extension tubes may be needed depending on the backfocus of the camera. You need to know how much distance there is between the cameras T-thread and the ccd chip. It is important that the distance from the back of the field flattener to the chip be maintained at 55 mm. So if the ccd camera has a backfocus of only 35 mm, a 20 mm extension will be needed. See the example below.
In this example the camera had a 35 mm backfocus, so a 20 mm extension tube was needed. It threads in between the back of the field flattener/reducer and the camera as shown. In this case the extension tube must be a standard t-thread (M42 X.75).