Other Telescope Accessories at BuyTelescopes.com

Effectively cleans filmy residue at the microscopic level. Increases resolution and light transmission, restoring optics to their original performance level. Will not damage optical coatings. Also reduces dew formation.

$4.95

Sky Engineering RJ11 to 5-Pin Encoder Adapter Cable w/3.5" Wires

RJ11 to 5-pin encoder adapter cable with 3.5" wires.

$5.00

Sky Engineering RJ11 to 5-Pin Encoder Adapter Cable w/2.0" Wires

RJ11 to 5-pin encoder adapter cable with 2.0" wires.

$5.00

Losmandy CW Shaft Safety Screw & Washer

CWSS - Counterweight Shaft Safety Screw and Washer

$8.00

Lumicon 49mm to 48mm Step Ring

The LP1020 Step Ring has 49mm exterior/male threads and 48mm interior/female threads, both with thread-pitch of 0.75mm.

$12.95
$10.00

Optec (CCD Photo Accessories) 6-ft. RJ-12 Reverse Cable

To attach the Pyxis to the COM (RS-232 serial) port of a computer requires a special cable. These cables are flat 6-wire stranded with RJ-12 modular connectors on both ends. They are typically refered to as reverse cables since each pin number on one connector is connected to the same number on the other end.

$10.00

Takahashi Touch-Up Paint (Green)

Touch-Up Paint, Green.

$13.00

Takahashi Touch Up Paint (White)

Touch up paint white.

$13.00

Optec PC Serial Port Converter, DB-9 to RJ-12, for TCF-S Focuser

Allows PC communications with the TCF-S Focuser (stk. no. 17670) using any 9-pin serial port. An RJ-12 Reverse Cable is required for proper operation. See stock no. 17671 through 17675).

$15.00

Optec (CCD Photo Accessories) 12-ft. RJ-12 Reverse Cable

To attach the Pyxis to the COM (RS-232 serial) port of a computer requires a special cable. These cables are flat 6-wire stranded with RJ-12 modular connectors on both ends. They are typically refered to as reverse cables since each pin number on one connector is connected to the same number on the other end.

$15.00

Optec 6-Foot Cable, SBIG ST-4/5/6 CCD Camera to Hand Controller, DB-9 to RJ-11

6-Foot Cable, SBIG ST-4/5/6 CCD Camera to Hand Controller, DB-9 to RJ-11

$15.00

TeleVue Flat Bar/Base to Adapt a Starbeam Universal Mount to a Televue Ring Slot

$15.00

Scopetronix AutoStar Computer Cord

Works with #497 AutoStar only. Allows connection of AutoStar to a standard 9 pin computer serial port for computer control and AutoStar firmware updates. Black coiled cord is 12 feet in length. Can easily be further lengthened by using standard telephone extension cords. Triple tested for reliability.

$19.95

TeleVue Bino Vue Flat Coupler

Bino Vue Flat Coupler replaces the ¾” long black nose piece on your Bino Vue.

$23.99

Optec 6-ft. Serial Cable for SSP Photometers, DB-9 F/F.

Optec 6-ft. Serial cable for SSP photometers, DB-9 F/F.
RS-232 cable for connection between PC DB-9 serial port and DB-9 port on SSP photometers.

$24.00

Optec (CCD Photo Accessories) Model WIS PC Communications Cable

Optec Model WIS PC Communications Cable.
20’ ft. long serial connection cable for PC configuration of the Precipitation and Wind Sensor Modules.

$25.00

Astrozap AstroStrap dew heater for .965 inch eyepiece and finder scope

AstroStrap dew heater for .965 inch eyepiece and finder scope

$25.00

Losmandy Gemini PC Cable

GCC - Losmandy Gemini PC Cable

$25.00

Optec 12-Foot Cable, SBIG ST-4/5/6 CCD Camera to Hand Controller, DB-9 to RJ-11

12-Foot Cable, SBIG ST-4/5/6 CCD Camera to Hand Controller, DB-9 to RJ-11

$25.00

Optec (CCD Photo Accessories) 25-ft. RJ-12 Reverse Cable

To attach the Pyxis to the COM (RS-232 serial) port of a computer requires a special cable. These cables are flat 6-wire stranded with RJ-12 modular connectors on both ends. They are typically refered to as reverse cables since each pin number on one connector is connected to the same number on the other end.

$25.00